Lighting CalculatorPlan light with clear assumptions

Lighting calculators / Light & unit conversions

Plan the light. Understand the numbers.

Light Distance Calculator

Doubling distance gives one quarter of the original illuminance in a valid inverse-square model. Tripling distance gives one ninth. This describes a geometric change from a known reading; it does not require guessing the lamp’s total lumens.

Your lighting inputs

lux
m
m

Starting values are illustrative. Check units and assumptions below. Calculate submits your inputs to this site’s result page.

Reset

Your result

Ready to calculate

Enter your values and press Calculate. The result will open on the calculation page.

Published references · Clear assumptions · No sign-up

The method

Formula and calculation steps

E₂ = E₁ × (distance₁/distance₂)² for the same direction and orientation.

Estimate relative illuminance change with distance under a point-source inverse-square model.

  1. Choose a measurement plane and use compatible units for all inputs.
  2. Obtain appropriate product data or representative measurements for the stated model.
  3. Submit the form, then interpret the result with the assumptions and limits below.

Keep source output, direction and receiver orientation fixed. Near-field panels, optical focusing, reflections and intervening media can invalidate this scaling.

Relative light intensity and inverse-square examples

Doubling distance gives one quarter of the original illuminance in a valid inverse-square model. Tripling distance gives one ninth. This describes a geometric change from a known reading; it does not require guessing the lamp’s total lumens.

For a controlled biology or physics demonstration, keep the sensor angle and lamp settings fixed and measure ambient light separately. A relative illuminance prediction is not automatically a prediction of biological response, photosynthesis or camera exposure because spectrum and the receiving system also matter.

Check the numbers

Light Distance Calculator: calculated examples

These are computed scenarios using the same server calculation as the form. They are not manufacturer ratings or prescribed design values.

Worked example with stated inputs

Illuminance at first distance = 500 lux; First distance = 1 m; New distance = 2 m.

OutputComputed result
Inverse-square illuminance125 lux
Relative to first reading25 %

How one input changes the answer

ScenarioChanged inputResult
0.5 mNew distance2,000 lux
1 mNew distance500 lux
1.5 mNew distance222.222222 lux
2 mNew distance125 lux
3 mNew distance55.555556 lux
4 mNew distance31.25 lux
6 mNew distance13.888889 lux

Unchanged inputs use: Illuminance at first distance = 500 lux; First distance = 1 m; New distance = 2 m. Results retain the model limitations described above.

Common questions

What is the equation for relative light intensity?

For a valid point-source comparison, the ratio E₂/E₁ is (d₁/d₂)².

Why do measurements differ from the inverse-square result?

Check ambient light, reflections, sensor orientation, near-field source size and directional output.

Does half the distance mean twice the light?

In the ideal model it means four times the illuminance, not twice.

Can this find lux from a watt rating?

No. An electrical watt rating needs photometric output and geometry before it determines surface illuminance.

Which assumptions should I check?

Match the units, measurement plane and equipment boundary stated on this page. The starting values and comparison cases are chosen examples, not universal recommendations or current manufacturer ratings.

Where are the formula references?

Published references are listed at the bottom of this page as plain-text website addresses. The example tables are calculated from the displayed method rather than copied from proprietary tables.

Formula sources and references

References support the underlying methods and units. Chosen example inputs are not universal recommendations, current tariffs or proprietary test results.

  • Australian Government: Lighting Manual, inverse-square and cosine lawshttps://www.energyrating.gov.au/sites/default/files/2022-12/Lighting%20Manual%20-%20Main%20Body%20-%20Final%20ex%20Appendices.pdf