Lighting CalculatorPlan light with clear assumptions

Lighting calculators / Plant light & exposure

Plan the light. Understand the numbers.

PPFD to DLI Calculator

Daily light integral accumulates photons over an entire day. A constant 200 µmol/m²/s for sixteen hours gives 11.52 mol/m²/day. The factor 3,600 converts hours to seconds and one million converts micromoles to moles; neither is an empirical plant-growth coefficient.

Your lighting inputs

µmol/m²/s
h/day

Starting values are illustrative. Check units and assumptions below. Calculate submits your inputs to this site’s result page.

Reset

Your result

Ready to calculate

Enter your values and press Calculate. The result will open on the calculation page.

Published references · Clear assumptions · No sign-up

The method

Formula and calculation steps

DLI mol/m²/day = average PPFD × light hours/day × 3,600 ÷ 1,000,000.

Integrate a stated photon flux density over a photoperiod to estimate daily light integral.

  1. Choose a measurement plane and use compatible units for all inputs.
  2. Obtain appropriate product data or representative measurements for the stated model.
  3. Submit the form, then interpret the result with the assumptions and limits below.

For varying daylight, integrate actual intervals rather than treating the peak as the daily average. No crop recommendation or spectral expansion is supplied.

Daily photon dose from PPFD and light hours

Daily light integral accumulates photons over an entire day. A constant 200 µmol/m²/s for sixteen hours gives 11.52 mol/m²/day. The factor 3,600 converts hours to seconds and one million converts micromoles to moles; neither is an empirical plant-growth coefficient.

In a greenhouse, sunlight and supplemental lighting vary over time. Sum their compatible interval integrals rather than using a single noon reading for all daylight hours. Keep conventional PPFD and extended-spectrum ePPFD boundaries distinct when comparing instruments or targets.

Check the numbers

PPFD to DLI Calculator: calculated examples

These are computed scenarios using the same server calculation as the form. They are not manufacturer ratings or prescribed design values.

Worked example with stated inputs

Constant or time-averaged PPFD = 200 µmol/m²/s; Photoperiod per day = 16 h/day.

OutputComputed result
Daily light integral11.52 mol/m²/day
Average input PPFD200 µmol/m²/s
Photoperiod16 hours/day

How one input changes the answer

ScenarioChanged inputResult
4 h/dayPhotoperiod per day2.88 mol/m²/day
8 h/dayPhotoperiod per day5.76 mol/m²/day
12 h/dayPhotoperiod per day8.64 mol/m²/day
16 h/dayPhotoperiod per day11.52 mol/m²/day
24 h/dayPhotoperiod per day17.28 mol/m²/day

Unchanged inputs use: Constant or time-averaged PPFD = 200 µmol/m²/s; Photoperiod per day = 16 h/day. Results retain the model limitations described above.

Common questions

How do I calculate DLI from PPFD?

Multiply representative average PPFD by hours and 0.0036, using the same spectral measurement basis.

Can I use the noon PPFD for twelve hours?

Only if it genuinely represents the average for those hours. Otherwise the integral can be greatly overstated.

Can I convert DLI back to average PPFD?

Divide DLI by 0.0036 times the positive photoperiod hours.

Does the result choose a plant’s ideal photoperiod?

No. It calculates the entered photon exposure and does not prescribe crop conditions.

Which assumptions should I check?

Match the units, measurement plane and equipment boundary stated on this page. The starting values and comparison cases are chosen examples, not universal recommendations or current manufacturer ratings.

Where are the formula references?

Published references are listed at the bottom of this page as plain-text website addresses. The example tables are calculated from the displayed method rather than copied from proprietary tables.

Formula sources and references

References support the underlying methods and units. Chosen example inputs are not universal recommendations, current tariffs or proprietary test results.

  • Apogee Instruments: Daily Light Integral, Measuring Light for Plantshttps://www.apogeeinstruments.com/daily-light-integral-measuring-light-for-plants/